The Fluid Controller is designed to start the pump when the system pressure falls, upon start up the unit continues to pump until the demand stops, at which point the pump is stopped. Should there be a lack of water, the fluid controller has dry run protection and will go into fault to protect the pump. If this occurs, check for adequate water supply to the pump, press and hold the blue button until the system has re-pressurised. The pump may require bleeding again to release the air. The Fluid Controller has two indicator lamps: –
Power indicator : Power on, pump ready to run
Status indicator : Pump Run
Pressure Gauge : Shows system pressure
Status Indicator flashing : Dry run lack of water
The Fluid Control allows automatic operation of the pump without the use of a separate pressure vessel.
Note : This model will operate up 15M static height above the controller. If you require greater height, contact our sales team for an alternative unit.